Hobby Adhesives Hobby Adhesive News Hobby Adhesive Tips and Tricks Hobby Adhesives Tips and Tricks
The surface properties of some materials, such as being acidic or having very low moisture content, slow down the curing of cyanoacrylates. CA accelerator is formulated to harden CA in ten seconds or less. Accelerator allows large gaps to be filled in loose fitting joints and cures the excess CA that sometimes oozes out of joints so that objects can be handled within seconds without the worry of sticking one’s fingers to the parts. Accelerator makes the repair of household items much easier.

Insta-Set - Accelerator for Cyanoacrylate Adhesive - BSI

INSTA-SET™ is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization. INSTA-SET™ in a spray bottle is normally used to cure the CA that flows from joints when parts are pressed together. Applying an additional bead of thick CA along a seam and then curing it with INSTA-SET™ significantly enhances a joint’s strength. For difficult to bond materials, INSTA-SET™ can be applied to one surface and CA to the opposite surface. When brought together, they will bond instantly. INSTA-SET™ is formulated with a strawberry scent and activates CA in 6 to 8 seconds without any degrading of the CAs strength, which can occur with many other accelerators. It is compatible with all surfaces, even clear plastic and white foam.

un-cure - debonder for Cyanoacrylate Adhesive - BSI

UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option.
cyanoacrylates - BSI odorless cyanoacrylates - bsi accelerators - bsi foam-cure - bsi threadlockers - bsi
adhesive accessories - bsi How to Use Cyanoacrylates - bsi Epoxies - bsi Adhesive Selection Chart - bsi
©2015 Bob Smith Industries, Inc.   site design: Studio 101 West Marketing & Design